They’re required to be individually labeled/categorized. And supposed to be on 2 exterior walls, and any doors, and on the containers themselves

Bio66, class number below 100 suggests it’s a remedial course.

Taiwan iirc, and they have a 32% tariff from US.

Plus if the show becomes a smash hit halfway through the season, you might get more money out of advertisers

Where would you find steel toed boots, I haven’t seen a child miner section section at most Walmarts

I wouldn’t want to fly in airspace controlled by Texas. Too much risk of crash landing and being stuck there

Tldw: get some thin heat syncs 75-80c temps on the ssds

No, it still does. At least at this moment

Increased resolution probably wouldn’t make a difference, but keeping the framerate at a steady 30 (or even better 60) would make a noticeable difference. At least it did when I played it on PC

Police: if you’re not doing anything illegal, you wouldn’t mind if I strip searched you, right?

Also Trump plaza hotel in 1992 (separately from the casino), and Trump entertainment resorts (casino) in 2009

If you squint just right, the door close button looks a little sus

Lol those nagging systems are now required safety features as of 2023, so any vehicle without them doesn’t meet today’s standards.

Does any 25 year old car meet today’s safety standards?

I’d argue the imported ones do meet all applicable standards, since they’re exempt.

Look at Mr Rich Guy here with enough money to afford to own an enciclopedia

Community (s3e14) had some good info on where to start

Yeah a cheap switch probably wouldn’t cut it. You’d need a more expensive managed switch to do segregated vlans, which would balloon the budget.

Not sure on veth segregation, but you could probably try with equipment you already have (onboard nic w/ veths > unmanaged gbit switch)

I’ve been looking at the open banana pi router since it has openwrt (debian/Ubuntu too). I think I’m going to wait and hope they put more multi-gig ports on next one tho.

You can probably use it, but you will not get full throughput on all the ports at the same time. 3.5/6 max real world.

My advice, get a cheap pcie4 10g nic and a 10g switch with multiple ports, but idk what you’re trying to do.

Nope. Pittsburgh yinz is less sophisticated than the victorian English y’all.

I think you’re missing the point of a riser. I’d the motherboard only has a 3.0x1 port, plugging in an x16 riser means it’ll still only be x1 electrically, but it can physically fit larger cards. If the back of the slot is open already there not much point of using a riser since you can physically fit larger cards already.

• If your board has pcie 3.0x1, you want the pcie 3.0 card. Running at 2.0x1 reduces speed by 50%